Zebra MZ series Installation And User Manual - page 5
MZ Series Quad Power Station
Using the Power Station
The MZ series Quad Power Station is designed to dock and
charge up to four MZ series printers of either type simultane-
ously.
1. Ensure that the Power Station has been installed properly
per this manual. Ensure that the power supply is properly
connected and its power indicator light is on.
2. Slide a printer into any one of the four docking bays as
shown in Figure 4.
NOTE: If you are using a shoulder strap, ensure it is pulled away from
the printer when installing in the Power Station.
The printer’s charge status indicator will turn amber if the
printer is properly inserted and the battery is less than
90% charged.
The printer’s charge indicators will allow you to monitor the
Figure 4: MZ Series Quad Power Station
continued
5
MZ Power Station Installation and User Guide
Green (Power)
Indicator
Slide Printer into docking bay
MZ 220 Printer
MZ 320 Printer
Amber/Green (Charge)
Indicator