Zebra QK 220 User Manual - Using Pcmcia Radio
35
QL Series User Guide
QL 320/320 Plus Wireless Local Area Network (WLAN) Module
Using PCMCIA Radio
The following section only applies when the PCMCIA WLAN module (FCC ID: I28-
QL320352) is installed in the QL 320 or QL 320 Plus printer (note that only one of the
radio options can be installed in the printer at one time). The antenna used for this
transmitter must not be co-located or must not operate in conjunction with any other
antenna.
The FCC ID number label is on the front of the module for QL 320 and on the back
label of QL 320 Plus. On all models the text can be read with the module installed.
WARNING: Use of the QL 320/320 Plus with the radio module
marked with FCC ID: I28-QL320352 meets the FCC requirements
for radio frequency (RF) radiation exposure in the standard body
worn configuration with no minimum separation. In this
configuration, which applies whether the belt clip or shoulder
strap is used, the face of the printer from which paper is
transported is facing away from the user’s body. The standard
configuration must always be used when the printer is body worn.
This configuration maintains the required 1 cm separation
distance.
The printer with this radio option has been SAR tested. The
maximum SAR value measured was .819 W/kg averaged over 1
gram.
European Regulatory Information for this Radio
AT
BE
CY
CZ
DK
EE
FI
FR
DE
GR
HU
IE
IT
LV
LT
LU
MT
NL
PL
PT
SK
SI
ES
SE
GB
Note: -Member states in the EU with restrictive use for this device are crossed
out!
This device is also authorized for use in all EFTA member states (
CH, IS, LI, NO
)
0336
Important Notice:
This device is a portable RF printer intended for com-
mercial and industrial usein all EU and EFTA mem-
ber states except in France where restrictive use ap-
plies.
continued