Zebra QK 220 User Manual - Area
48
QL Series User Guide
Use the supplied cleaning pen or 70%
isopropyl alcohol on a cotton swab to
clean the print elements from end to end
(the print elements are located in the thin
gray line on the printhead).
Printhead
(Figure 20)
Peel bar
(Figure 20)
Clean thoroughly with the cleaning pen
or 70% isopropyl alcohol and a cotton
Area
Method
Interval
As needed
After every five
rolls of media
(or more often,
if needed)
Platen
Roller
(Figure 20)
Tear bar
(Figure 20)
Scraper
(Linerless units
only) Figure 20a
Clean thoroughly with the cleaning pen or
70% isopropyl alcohol and a cotton swab.
Clean thoroughly with the
cleaning pen or 70% isopropyl
alcohol and a cotton swab.
Exterior
Interior
(Figure 20)
As needed
After every five
rolls of media
(or more often,
if needed)
After every five
rolls of media
(or more often,
if needed)
Linerless media
requires more
frequent
cleaning
Platen Roller
(Figure 20a)
Interior
(Figure 20a)
Water-dampened cloth
Brush/air blow. Ensure the Bar Sensor, Gap
Sensor and Label Present Sensor windows
are free of dust.
Units with linerless platens:
Clean inside surfaces of Media supports &
Media Support Disks with the supplied
cleaning pen or 70% isopropyl alcohol on a
cotton swab.
QL220 Cleaning
Rotate the platen roller and clean it
thoroughly with the cleaning pen or 70%
isopropyl alcohol and a cotton swab.
Units with linerless platens: Rotate
platen & clean bearing points only. Avoid
use of alcohol on the surface of linerless
platens!
Cleaning Instructions
CAUTION- Use only cleaning agents specified below. Zebra
Technologies Corporation will not be responsible for damage
caused by any other cleaning materials used on this printer.
Clean the printer with either the cleaning pen supplied with the
printer or a cotton swab saturated with alcohol.
WARNING: To avoid possible personal injury or damage to
the printer, never insert any pointed or sharp objects into the
printer.