Zebra R 2844-Z User Manual - ^xa

^RT – Read Tag (continued)

Example:  This reads a block from a tag, and prints it on a label:

^XA

^RS1,0^FS

^FO20,120^A0N,60^FN1^FS

^FO20,100^A0N,20^FN2^FS

^RT1,7,3,0,5,0,0^FS

^RT2,2,2,0,5,0,0^FS

^XZ

The first ^RT command automatically detects the tag type, starting at block

7, reads three blocks of data in ASCII format.  It will retry the command 5

times if necessary.  A “void” label will be generated if the read is

unsuccessful after ‘r’ retries.  The data read will go into the ^FN1 location

of the recalled format.

The second ^RT command automatically detects the tag type, starting at

block 2, and reads two blocks of data in ASCII format.  It retries up to 5

times.  The data read will go into the ^FN2 location of the recalled format.

You can send data back to the host with the Host Verification command

(^HV).  Refer to the ZPL II manual to learn about this command.

980476-001A

39