Zebra R 2844-Z User Manual - Handling Voided Transponders

Handling Voided Transponders

Line #

Type this label format

Resulting printout

1.

^XA

See next page

2.

^RS,800,,2,P^FS

3.

^XZ

Line 1 Indicates start of label format.

Line 2 Moves the media to 800 dots from the top of the media (or

label length minus 800 from the bottom  (leading edge) and

voids the rest of the media in case of error.  The printer will

try to print two labels, then will pause the printer if printing

and encoding fail.

Line 3 End of label format.

The following figure shows the resulting voided label.  Note where the void

starts.  The media has been moved 800 dot rows from the top of the label

(label length minus 800 dot rows from the bottom (leading edge) of a label)

to bring the transponder into the effective area to read/write a tag.  If the

printer fails the operation, the rest of the media is voided.

48

980476-001A