Zebra R 2844-Z User Manual - Assembly

Replacing the TLP Print Head (Continued)

Assembly

The new print head comes with the clip

and ground screw attached.

1. Align the print head and bracket to

plug the left and right connectors into

the black and white wire bundles.

2. Attach the ground wire and secure it

with the screw.  Use a #2 Phillips

driver to tighten it.

3. Insert the bracket pegs into the left

side of the carriage.

4. Align the right side of the bracket and

insert the print head clip through the

right side of the ribbon carriage into

the bracket.

5. Slip the left end of the print head

spring into the left side of the ribbon

carriage; then slide the right end into

the other side.  The angle of the “V”

fits into the indent on top of the print

head bracket.

6. Clean the print head with the cleaning

pen.

Reload media and ribbon.  Plug in the

power cord.  Print a status report to ensure

proper function.

980476-001A

59