Zebra R 2844-Z User Manual - One to Three Labels.

The printing does not start at the top of the label, or misprinting of

one to three labels.

■

The media may not be threaded under the media guides.  Refer to

“Loading the Media” on page 9.

■

The printer needs to be calibrated.  Refer to “Auto Calibration” on page

14.

■

The correct media sensor may not be activated.  Manual calibration

selects the media sensing method for the labels being used (refer to the

^MN

command  in the ZPL II Programming Guide).

■

Verify that the Label Top (

^LT

) command is correctly set for your

application (consult the ZPL II Programming Guide).

A label format was sent to, but not recognized by, the printer.

■

Is the printer in pause mode?  If so, press the feed button.

■

If the status LED is on or flashing, refer to “What the Status LED is

Telling You” on page 61.

■

Make sure the data cable is correctly installed.

■

A communications problem has occurred.  First, make sure that the

correct communications port on the computer is selected.  Refer to

“Communicating with the Printer” on page 18.

980476-001A

65