Zebra TLP-2844 User Manual - page 28

Adjusting the Print Width

Print width must be calibrated when you use a roll with a different width

from previous media.

Print width may be set by using the Set Label Width (Q) command

(described in the programming guide).

Adjusting the Print Quality

Print quality is influenced by the heat of the print head, the speed of the

media and the type of media you are using.  Only by experimenting will

you find the optimal mix for your application.

If you find that the print darkness needs to be adjusted, refer to the heat

density (D) command (described in the programming guide).

If you find that the print speed needs to be adjusted, refer to the print speed

(S) command (described in the programming guide).

20

980485-001A