Zebra TLP-2844 User Manual - page 45

Media Handling

Problem

Solution or Reason

Label Dispenser

Printing continues

between labels.

1.

Make sure label-taken sensor is on.

2.

The label-taken sensor is blocked or dirty.  Remove any

scraps or dust.

3.

Continuous media may be set.  Verify form length setting

through programming Q command.  See the programming

guide.

Prints one label and

then stops.

1.

Verify the quantity has been correctly set.

Cutter Operation

Blade cuts through

labels instead of

cutting liner between

labels.

1.

Verify form length setting through programming

Media jammed in

cutter.

1.

Unplug power and interface cables.  Use tweezers to

remove scraps from cutter opening.

Blade fails to cut

direct thermal paper

or label liner.

1.

Use programming C command to cycle cutter several times

without media to perform a self-cleaning.  See the

programming guide.

2.

Cutter must be replaced.

980485-001A

37