Zebra TLP-2844 User Manual - Assembly

Replacing the TLP Print Head (Continued)

Assembly

The new print head comes with the clip

(A) and ground screw (B) attached.

1. Detach the wire cover (C).

2. Detach the ribbon take-up hub (D).

3. Align the print head and bracket (E) to

plug the left and right connectors into

the black and white wire bundles.

4. Attach the ground wire (F) and secure

it with the screw (B).  Use a #2

Phillips driver to tighten it.

5. Insert the bracket pegs into the left

side of the carriage.

6. Align the right side of the bracket and

insert the print head clip (A) through

the right side of the ribbon carriage

into the bracket.

7. Slip the left end of the print head spring (G) into the left side of the

ribbon carriage; then slide the right end into the other side.  The angle

of the "v" fits into the indent on top of the print head bracket.

8. Attach the ribbon take-up hub (D).

9. Attach the wire cover (C).

10. Clean the print head with the cleaning pen.

Reload media and ribbon.  Plug in the power cord.  Print a status report to

ensure proper function.

980485-001A

33

C

B

A

D

E

F

G