2Wire 2710HGV-TNZ User Manual - page 82
of
86
82
Changing to the Bridging Mode
By default, the 2Wire gateway is configured in the routing mode.
Note: This feature is NOT currently supported on the Telecom Broadband Network
When routing is disabled, the NAT and the DHCP server are also disabled.
To change the 2Wire gateway to the bridging mode:
1. Open a Web browser and access the gateway user interface by entering http://gateway.2wire.net.
2. Click ; the Summary Status page opens (
Figure 70
).
Figure 70: Broadband Summary Status Page
3. Click
Link Configuration
; the Link Configuration page opens
4. Scroll down to the Routing pane (
Figure 71
).
Figure 71: Broadband Routing Pane
5. Deselect the
Enable checkbox.
6. Click
Save.