3D Systems CUBE User Manual - page 33
Other manuals for CUBE:
User Manual, Quick Start Manual, Quick Start Manual, User Manual, User manual
Manual is about: Personal 3D Printer 3rd Generation
of
60
33
Set up a computer (WPS) network (cont’d)
5. Tap on “WI-FI SETUP”
Tap Here
6. Tap on “WPS” in the menu screen. The next screen will show your printer connecting to your computer and then “WPS Con-
nected” if the connection was successful. If connection was not successful, unplug the power to your Cube and then plug
your Cube in; Repeat the WPS WI-FI set up until the touch screen reads “WPS connected.”
Switching from ad-hoc to WPS connection or vice versa:
1. Close out Cube Software.
2 Disconnect the Cube’s wireless connection through the “Internet Access” menu on your operating system.
3. Now follow steps for WPS / ad-hoc set up.
4. Re-open your software after your Cube successfully connects to WPS/ad-hoc.
Tap Here