3D Systems CUBE User Manual - page 34
34
NON-WIRELESS COMPUTER SET UP (WITHOUT WI-FI OPTIONS)
15
If you are not connected to a network, you can download your creations from your computer and save them to your USB memory
stick for printing.
•
WhenprintingwiththeUSBmemorystick,thefilemustbeinthemainfolderlocatedonthememorystick.Ifitisputinto
another folder such as a subfolder, it cannot be accessed from Cube touchscreen.
•
Install your USB memory stick into your computer’s USB connection and save your creation to your USB memory stick.
•
When you are ready to print your creation, install your memory stick into the Cube’s USB connection and select from the
touchscreen the Creation to be printed.
UPDATE CUBE FIRMWARE
16
2. If your USB memory stick is connected to the Cube, please remove the memory stick (the screen will display the directions
to do this). Tap the “NEXT” arrow on the display; locate the USB cable and connect the cable to the Cube USB port located
on the back of the Cube (again, these instructions will be displayed on the screen). Connect the other end of cable to your
computer’s USB port.
NOTE:NeverleavetheUSBcableconnectedexceptwhenupgradingthefirmware
3. Tap the “NEXT” arrow. “SETTINGS SAVED” will be displayed at the top of the screen. You will have 6 seconds to press
andholdforsix(6)secondsthecontrolbuttonuntil“Cubefirmwareloader”appearsonthescreen.Ifthebuttonisreleased
beforethefirmwarescreenappears,thescreenwillgoblank.Repeat“Step1”torestarttheupdatefirmwareprocess.
Connect USB Cable
1. Tap on “Setup” on the Cube touch screen and scroll to “Update Firmware.” Finger tap “Update Firmware.”
Tap Here
Tap Here One Time
3. Press and hold the control button
2. Remove USB Memory Stick