3D Systems CUBE User Manual - page 41
Other manuals for CUBE:
User Manual, Quick Start Manual, Quick Start Manual, User Manual, User manual
Manual is about: Personal 3D Printer 3rd Generation
of
60
41
PRINTING PREPARATION
1. StandCubeStickonit’scapuntiltheglueflowstothecap;removecap.
2. Remove print pad from the Cube; slowly apply a coat of glue in rows moving the bottle up and then down until the
glue is evenly distributed on the entire print pad. Check the pad after applying the glue to ensure there are noticeable
gaps where glue was not applied. If so, apply glue to the gaps.
3. Replace glue cap after use.
4. Place print pad on the print pad platform.
NOTE: The Cube Stick™ will have to be applied on the print pad every time you start a new creation.
Caution: Do not use any other type of glue other than Cube Stick. Doing so can damage your print
tip and the print pad.
21