3D Systems CUBE User Manual - page 50

50

REPLACING MATERIAL CARTRIDGE

24

Do not change cartridge or material during printing; doing so can cause damage to your Cube.

Cube 

Tube

 2.  Pull material out of print jet and press “Next.”

 1.  Pull Cube Tube away from top of print jet. Please do not pull the 

material out until the touch screen instructs you to do so.

Pull Material Out

3.  Remove cartridge from Cube and remove the Cube Tube from material.  Re-

place thumb screw into cartridge to hold the unused material in place. Refer 

to “Material Cartridge Installation,” for instructions on how to install your new 

cartridge.

Cube 

Tube

Thumb Screw

NOTE: After the material is pulled out from the print jet, it may be necessary to remove material debris that may 

be clogged at the print tip. Using the unclog tool, insert the tool’s point into the print jet; if debris is present, it 

will protrude from the print tip. 

Unclog Tool