3D Systems CUBE User Manual - page 53
53
MAINTAINING YOUR CUBE
26
Cleaning the Exterior
•
Clean the Cube’s exterior with a lint free cloth and water.
Dampen the cloth with water and wipe the outer surfaces of
any debris that is visible.
Cleaning the Print Pad
•
Submergeprintpadinacontainerfilledwithwarmcity(tap)
water. Please do not use well water; it contains certain min-
eralsthatmaymakeyourcreationdifficulttoremovefrom
the print pad.
•
Rinse pad under tap water and dry using a lint free wipe.
Cleaning the Print Tip
WARNING –
PRINTJET NOZZLE TIP
BECOMES EXTREMELY HOT DURING
SET-UP AND OPERATION. DO NOT
TOUCH NOZZLE.
•
Using small pliers, pull away any plastic debris away from the nozzle tip.
•
If the debris is stubborn, the nozzle may need to be heated to make the debris soft
enough to remove.