3D Systems CUBE User Manual - page 52
Other manuals for CUBE:
User Manual, Quick Start Manual, Quick Start Manual, User Manual, User manual
Manual is about: Personal 3D Printer 3rd Generation
of
60
52
Removing Supports (If Required)
•
Carefully break the supports away from your creation. In places where the supports are inside your creation and are hard to
reach, use small needle nose pliers (not supplied) to remove the supports.
Removing Raft (If Required)
•
Ifsupportsarepresent,usesmallpliersfirsttoremovesupportfrompart.Useplierstoremovetheraftawayfromthebottomof
your creation. In places where the supports are inside your creation and are hard to reach, use little wire snips or needle nose
pliers to remove the supports.