3D Systems CUBE User Manual - page 59
Other manuals for CUBE:
User Manual, Quick Start Manual, Quick Start Manual, User Manual, User manual
Manual is about: Personal 3D Printer 3rd Generation
of
60
59
F
RE-SET PRINT JET GAP
When the Cube is operating, the print tip on the print jet and the print pad become hot; avoid
touching these areas until they have cooled down.
Theprinttipmustbere-settothecorrectdistancebetweenthenewprinttipandtheprintpadtoensurethefirst
printed layer sticks properly.
1. Finger tap “Set Up” on the touchscreen and press “Next” until “Set Gap” appears.
Tap Here
2. Finger tap “Set Gap;”
The print jet and print pad will move into position to set the gap. Next, place a standard
sheet of paper between the print tip and the print pad. If the paper can not slide between the print tip and print pad,
tap the “down” arrow key on touchscreen.
Tap Here