3D Systems CubePro User Manual - page 17

13

3D Systems, Inc

.

16 . 

Align the jet wiper assembly bottom tab (A) with the slot in the floor (B) and slide 

the jet wiper assembly downward . 

NOTE: If the jet wiper assembly is fully seated into the keyhole 

slots but the bottom does not rest on the thumbscrew head, remove 

the jet wiper and turn the thumbscrew counter-clockwise until the 

jet wiper bottom rests on the thumbscrew head and the keyhole 

slots are fully seated . This may require repeated removals and 

re-installations of the jet wiper . If the keyhole slots will not seat, 

the thumbscrew may need to be adjusted downward by turning 

clockwise .

NOTE: Refer to the section titled 

Adjusting the Jet Wiper Assembly

for information about adjusting the jet wiper scraper height .

17 .  Remove the print pad from the box and place it onto the print platform with the 

round magnet on the bottom of the pad inserted into the triangular opening on 

the platform . Ensure the print pad is securely seated on the print plate .

18 .  Connect the power cord to the power inlet port (B) on the right side of the printer 

and the other end to a wall outlet . Press the power on/off switch (A) to power on 

the CubePro .

19 .  Press the on/off button (A) beside the LED screen to power on the CubePro 

touchscreen display .

20 .  Press the touchscreen to navigate to the main menu . 

NOTE: Turning on the touchscreen will also turn on the interior LED 

lights .

A

A

B

A

B