3D Systems CubePro User Manual - page 26

22

3D Systems, Inc

.

8 .  (

1

) Push the front of the cartridge into place . (

2

)

Then, push the cartridge 

handle downward until the cartridge is fully seated in its mount . Select the 

checkmark

 to continue .

NOTE: Ensure the front of the cartridge (A) where the material exits 

is seated under the clamp roller and between the vertical alignment 

pins in the cartridge bay .

CAUTION: If replacing the third cartridge, be sure to rotate the 

second bay cartridge to its vertical position before selecting the 

checkmark . 

NOTE: The print pad must be calibrated before printing your first 

creation . For more information, refer to the following section titled 

Calibrate Print Pad

 .

A

1

2