3D Systems CubePro User Manual - page 66

62

3D Systems, Inc

.

CALIBRATING THE PRINT PAD

The print pad is leveled at the factory and this adjustment may not be necessary for your printer . If your creations are not printing as 

expected, check the level of the print pad .

1 .  Navigate to the 

Print Plate Calibration

 screen and select 

LEVEL PLATE

 . 

Select the 

checkmark

 to continue .

NOTE: The print pad will raise and the print jets will move to the 

left rear of the print pad .

2 .  Select the upper right corner of the triangle on the touchscreen display .

NOTE: The print jets will move to the right rear of the print pad .

3 .  Using the designated page from the Setup/Repack instructions, slide the paper 

between the print jets and the print pad .

NOTE: If there is a slight resistance, proceed to step 5 .

NOTE: The red line (C) illustrates the gap between the print jets (A) 

and the print pad (B) .

4 .  If the paper slides easily between the print jets and print pad, rotate the 

adjustment knob counter-clockwise until there is a slight resistance . 

CAUTION: If the print pad is set too high, damage to the print pad or 

print jets may occur .

NOTE: If the paper can not be inserted between the print jets and 

the print pad, turn the adjustment knob clockwise until there is a 

slight resistance on the paper .

A

B

C