4RF Aprisa XE User Manual - page 190
Maintenance | 189
Rebooting the terminal
The local or remote terminals can be rebooted by SuperVisor.
You can specify a ‘Soft Reboot’ which reboots the terminal without affecting traffic or a ‘Hard Reboot’
which reboots the terminal (similar to power cycling the terminal).
You can specify an immediate reboot or setup a reboot to occur at a predetermined time.
To reboot the terminal:
1.
Select Link or Local or Remote > Maintenance > Reboot.
2.
Select the Reboot Type field:
None:
Do nothing.
Soft
Reboot:
Reboots the software but should not affect customer traffic.
Hard
Reboot:
Reboots the systems and affects customer traffic.
3.
Select the Reboot Command field:
None:
Do nothing.
Reboot
Now:
Execute the selected reboot now.
Timed
Reboot:
Set the Reboot Time field to execute the selected reboot at a later date and time. This feature can
be used to schedule the resulting traffic outage for a time that has least customer impact.
Cancel
Reboot:
Cancel a timed reboot.
4.
Click Apply to execute the reboot or Reset to restore the previous configuration.