5Star Systems Spica 250M User Manual - page 17
5Star Systems – Spica 250M – User manual
Tel: 0031 23 55 44 611
17
7.1 Main functions
DMX 512 Address settings
The letter "A" flashes. Use the [Up] and [down] keys to select required
address (001 - 497) and press [Enter] to confirm or [Mode] to cancel and
return to the main menu.
Pan reverse
This function allows you to invert the pan movement. Use the [Up] and [Down]
keys to select "On" if you wish this feature or "Off" if you don’t wish this feature
and press [Enter] to confirm or [Mode] to cancel and return to the main menu.
Tilt reverse
This function allows you to invert the tilt movement. Use the [Up] and [Down]
keys to select "On" if you wish this feature or "Off" if you don’t wish this feature
and press [Enter] to confirm or [Mode] to cancel and return to the main menu.
Movement resolution
By this function you can adjust the desired movement resolution 8 or 16 bit.
Use the [Up] and [Down] keys to select "On" if you wish the 16bit high
resolution or "Off" if you wish only 8 bit resolution and press [Enter] to confirm
or [Mode] to cancel and return to the main menu. Note: If you adjust the 16 bit
resolution the fixture will occupy 16 DMX channels, if you adjust the 8 bit
resolution, the fixture will be operated by only 14 DMX channels. Please, check
the DMX protocol.
Lamp On time
This option enables you to read the total number of hours that the lamp has
been powered On. Press [Enter] or [Mode] to return to the main menu. In
order to reset the counter to 0, you have to hold the [Up] and [Down]-button
and press the [Enter]-button.
Power On time
By this option you can read the total number of hours that the SPICA 250 has
been powered On. Press [Enter] or [Mode] to return to the main menu.
Switch On/Off the lamp
Use the [Up] and [Down] keys to select "On" if you wish the switch On the
lamp or "Off" if you wish switch Off the lamp and press [Enter] to confirm or
[Mode] to cancel and return to the main menu.
Demo sequences
This function allows you to run a special demo-test sequences without an
external controller, which will show you some possibilities of using SPICA
250M. Press [Up] and [Down] keys to select the "Mod1" or "Mod2"
sequences. The "Mod1" is suitable for projections on the wall, ceiling or ground
without any head-movement, the "Mod2" uses all SPICA 250 functions and
therefore is good for a complete introduction of the fixture.