5Star Systems Spica 250M User Manual - page 22
5Star Systems – Spica 250M – User manual
Tel: 0031 23 55 44 611
22
(colour-wheel error) This message will appear after the reset of the fixture if the
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the
stepping-motor is defective (or its driver circuit on the main PCB). The color-
wheel is not located in the default position after the reset.
(rotating gobo-wheel error) This message will appear after the reset of the
fixture if the magnetic indexing circuit malfunctions (sensor failed or magnet
missing) or the stepping-motor is defective (or its driver circuit on the main
PCB). The rotating gobo-wheel is not located in the default position after
the reset.
(rotating gobo indexing error) This message will appear after the reset of the
fixture and if the magnetic indexing circuit malfunctions (sensor failed or magnet
missing) or the stepping-motor is defective (or its driver circuit on the main
PCB). The rotating gobo is not located in the default position after the
reset.
(prism error) This message will appear after the reset of the fixture if the
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the
stepping-motor is defective (or its driver circuit on the main PCB). The prism-
wheel is not located in the default position after the reset.
This error message informs you that the fixture was overheating (occurred if the
ambient temperature is 45° C or more) and that the relay switched off the lamp.
This message will appear on the display until the temperature will be on a
suitable level, then the display will show the HEAt message meaning the
lamp is too hot (explanation sees above).
This message appears if the lamp lighting sensor is failed. Please, contact your
dealer.
This message will appear if the fixture was shortly disconnected from the main.
(PAN-yoke movement error) This message will appear after the reset of the
fixture if the yoke’s magnetic indexing circuits malfunction (sensors failed or
magnet missing) or the stepping motor is defective. (Or it’s driving IC on the
main PCB). The yoke is not located in the default position after the reset.
(TILT-head movement error) This message will appear after the reset of the
fixture if the head’s magnetic indexing circuit malfunctions (sensor failed or
magnet missing) or the stepping motor is defective. (Or it’s driving IC on the
main PCB). The head is not located in the default position after the reset.
It will appear if the frequency of the main is not standard 50 or 60Hz.