5Star Systems Spica 250M User Manual - 1. Safety
5Star Systems – Spica 250M – User manual
Tel: 0031 23 55 44 611
3
1. Safety
1.2 Safety instructions
Every person involved with installation and maintenance of this device has to:
- be qualified
- follow the instructions of this manual
CAUTION!
Be careful with your operations. With a voltage of 230V
you can suffer a dangerous electric shock when
touching the wires!
This device has left our premises in absolutely perfect condition. In order to maintain this condition and
to ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions and
warning notes written in this manual.
CAUTION!
Keep this device away from rain and moisture!
Unplug mains lead before opening the housing!
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the device.
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Never let the power-cord come into contact with other cables! Handle the power-cord and all connections
with the mains with particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Always plug in the power plug least. Make sure that the power-switch is set to OFF-position before you
connect the device to the mains. The power-plug has to be accessible after installing the device.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and
the power-cord from time to time.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power cord by the plug. Never pull out the plug by tugging the power-cord.
This device falls under protection class I. Therefore it is essential to connect the yellow/green conductor
to earth.
The electric connection, repairs and servicing must be carried out by a qualified employee.
Do not connect this device to a dimmer pack.
Do not switch the fixture on and off in short intervals as this would reduce the lamp’s life.
During the initial start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defective.
Do not touch the devices housing bare-handed during its operation (housing becomes hot)!