5Star Systems Spica 250M User Manual - page 4
5Star Systems – Spica 250M – User manual
Tel: 0031 23 55 44 611
4
For replacement use lamps and fuses of same type and rating only.
CAUTION! EYEDAMAGES!
Avoid looking directly into the light source
(meant especially for epileptics) !
1.3 Operating determinations
This device is a moving-head spot for creating decorative effects. This product is only allowed to be
operated with an alternating current of 230 V, 50 Hz and was designed for indoor use only.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your device. Leave the device
switched off until it has reached room temperature.
Never run the device without lamp!
Do not shake the device. Avoid brute force when installing or operating the device.
Never lift the fixture by holding it at the projector-head, as the mechanics may be damaged. Always
hold the fixture at the transport handles.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety
of others!
The minimum distance between light-output and the illuminated surface must be more than 1 meter.
Make sure that the area below the installation place is blocked when rigging, deranging or servicing the
fixture.
Always fix the fixture with an appropriate safety-rope. Fix the safety-rope at the correct holes only.
Only operate the fixture after having checked that the housing is firmly closed and all screws are tightly
fastened.
The lamp must never be ignited if the objective-lens or any housing-cover is open, as discharge lamps
may explode and emit a high ultraviolet radiation, which may cause burns.
The maximum ambient temperature ta = 45° C must never be exceeded. Otherwise, the lamp is switched
off and the fixture is out of operation for 5 minutes.
CAUTION!
The lens has to be replaced when it is obviously damaged, so that its
function is impaired, e. g. due to cracks or deep scratches!
Operate the device only after having familiarized with its functions. Do not permit operation by persons
not qualified for operating the device. Most damages are the result of unprofessional operation!