Ablephone AP-6000 User Manual - page 12
If that did not help, make sure the power is on. You should see two bright blue
lights turned on. Then check that all of the connections from the phone to
Dialer and from Dialer to the line are both correct and secure. Check
especially that you have connected your phone to the ‘phone’ jack and the
line to the ‘line’ jack on Dialer. If you reverse these connections, Dialer will not
work and you will hear nothing. If you still cannot hear anything, connect the
phone directly to the line, without Dialer. If you do not hear a dial tone now,
then either your phone or cable is at fault
Question: When I try to add a new name, I keep hearing ‘please repeat’ or a
warning sound, and the name will not train. What am I doing wrong?
Answer: This symptom usually has two main causes:
1.
You are trying to train the name while background noise
is present. This can be any noise from people in the room with you,
a TV or radio working in the same room, or even loud noises
coming from construction taking place near you. As mentioned
above, you should try and train names in a quiet environment.
2.
You are not repeating the name consistently during
programming. Try to say the name the same way when asked for it
twice during programming.
Question: When I try to dial a name or to erase a name, Dialer says “Name
not recognized”. What can be wrong?
Answer: Assuming you have trained this name in a quiet environment as
mentioned above, you may not be saying the name the same way you did
during programming. To listen to a playback of the name, use key ‘4’ while in
the main menu. (Please refer to Chapter One of this manual for exact
instructions.)
Question: Dialer now speaks in a language I do not understand. How can I
change it back to my desired language?
Answer: Pick up the handset. Press the pound key (#) to reach the main
menu. When you do, press the ‘0’ key to reach the language menu. Listen to
the different language options. When your desired language is heard, press
its index number.
12