Ablephone AP-6000 User Manual - page 6
Voice dialing
Please follow these easy steps to dial:
A.
Pick up the handset. If you have already trained Dialer with
names, it will ask you for name to dial. If you have trained it only with
digits, it will ask you for a number to dial. At the prompt, say the name
you wish to call or the first digit of the number you wish to voice dial.
B.
If you said a name, Dialer will playback the recognized name
and will dial the corresponding number. If Dialer did not recognize the
name, you will be asked to try again. If Dialer still does not recognize
the name after 2 or 3 attempts, please see the ’Frequently Asked
Questions’ section in Chapter Three for assistance
C.
If you said a digit, Dialer will respond with reading you back the
digit it recognized and will now wait for your next digit. Continue by
saying the digits of the number in this method. When you are done, say
the dial command. Dialer will now say 'Dialing…' and will repeat the
digits you have just said. Please listen to the read digits and verify they
are the digits you said. In case Dialer makes a mistake, simply hang
up. If all the digits are correct, Dialer will dial the number.
D.
At the end of the call, simply hang up as you always do.
E.
If you wish to redial the last number you said using digits, simply
say the dial command without any digits.
Please also note these following general important remarks:
1.
You can disconnect Dialer from AC power whenever
needed, without concern. The names and numbers will not be
lost, and your phone will continue to operate normally. The
same applies for a power outage.
2.
If you are using a cordless phone, please verify that the
sound on the line is ‘clean’ with no ‘white’ noises. These ‘white’
noises, usually occur when the mobile part of the cordless
phone is far from its base. Such noises can make it difficult for
Dialer to recognize names.
3.
To access the main menu, once memory has at least one
name stored in it, do the following:
a.
Pick up the handset.
b.
After Dialer prompts you for a name to call, press
the pound key (#).
6