Ablephone AP-6000 User Manual - page 7
4.
If you would like to dial a number manually, do the
following:
a.
Pick up the handset.
b.
After Dialer prompts you for a name to call, press
any of the dialing keys except the pound key (#). Dialer
will connect you directly to the telephone line so that you
can dial manually.
5.
Dialer is based on speaker-dependent voice-recognition
technology. This means that only the person who trained Dialer
can use it. However, two or more users can share Dialer. Each
user can store his/her own names and numbers, and then can
call them independently.
6.
Dialer works only with the phone plugged into it, and not
with other phones on the same phone line. Dialer will recognize
names best if the phone used for training continues to be the
one used with Dialer. Substituting another phone for the one
used for training can lead to poor recognition results. Multiple
copies of Dialer can be used on the same phone line, each
working independently with the phone to which it is connected.
Erasing a single name
Erasing a single name from memory can be accomplished in two different
ways, as described below:
Method 1:
A.
Pick up the handset. Dialer asks for a name to call. Press the
pound (#) key. The main menu will be played.
B.
Press the ‘2’ key. Dialer asks for a name to erase. Say the name
you wish to erase.
C.
If the name is found, Dialer asks you to confirm the erasure of
the name by pressing the ‘5’ key. [Any other action (for example,
hanging up) will cause the name not to be erased.]
D.
Press the '5' button. The name will be erased and Dialer will
return to the main menu. If this was the last name remaining in
memory, a 'Memory Empty' prompt and a sound will be heard.
Method 2:
A.
Pick up the handset. Dialer asks for a name to call. Press the
pound key (#). The main menu will be played.
7