Ablephone AP-6000 User Manual - page 5
C.
Dialer is shipped with a blank memory. Pick up the handset. The unit
will play back the main menu. Press ‘1’ to add a new name.
D.
When asked, say the name to be added. Speak clearly but as normally
as possible. When prompted to repeat the name, do so. If the training
of the name has been successful, Dialer will ask you for the
corresponding phone number. If the training has failed, Dialer will
issue a sound that means a general error has occurred, or Dialer will
state the specific problem that has occurred.
E.
When prompted, enter the number using your phone's keypad. You
can enter up to 45 digits. You can program pauses (3 seconds each)
within the phone number (to be used by calling cards or other
advanced services) by pressing the star key (*) twice. Press the pound
key (#) when you are done entering the number. Dialer will read back
the phone number you have just entered and then will store the name
and its number.
F.
Dialer will automatically ask you for the next name. If you do not wish
to continue, simply hang up or press the pound key (#) to get back to
the main menu.
Training Dialer with commands (digits)
A. Choose a quiet moment, where no TV sounds or other background
noises are present. Training the unit in a noisy environment will result
in poor recognition rates later on.
B.
Pick up the handset. If you have already trained Dialer with names, you
will hear the prompt "name to dial please". Press the # key following
this prompt. If you did not train it with names yet, you will hear the main
menu. Press '5' to train the commands.
C.
Dialer will now ask you to say the ten digits and star. You will need to
say each digit twice. After each digit, you will hear a playback of the
digit you just said. Move on to the next digit.
D.
Once all digits have been trained, Dialer will ask you to train the dialing
command. This can be any word you wish but 'Dial Number' is always
a good choice.
That’s all! Dialer is now ready to listen to your voice and dial for you.
5