Ablephone AP-6000 User Manual - page 4
Chapter One
This chapter describes how to install Dialer, add names, erase a name or all
names, listen to stored names, and, most importantly, dial a name using only
your voice!
Installing Dialer
To use Dialer, install it by following these three steps:
A.
Connect the supplied power adaptor to the AC wall outlet and to the
Dialer jack marked ‘Power’. When the power is applied, you should see
two bright blue lights light up, one on the 'phone' jack and the other on the
'line' jack of the Dialer unit. They indicate that the power is ON. If you do
not see these lights, please see the ‘Frequently Asked Questions’ section
in Chapter Three for assistance.
B.
Connect the modular cord from your telephone to the Dialer jack
marked ‘Phone’.
C.
Connect the supplied modular cord from the Dialer jack marked ‘Line’
to the modular phone jack on your wall.
That’s It! The Dialer is now ready to be used.
Adding names & numbers
Once the Dialer is connected, you can start adding names. Please follow
these steps:
A.
Make a list of the names and numbers you wish to add to Dialer. This
list is important because it will simplify training the Dialer. Consider
these tips:
•
Do not use very short names like ‘Joe’. Instead,
use both first and last names.
•
If two names are very similar (first name, or last
names, are the same in both names), try training one of
the names in reverse order.
B.
Choose a quiet moment, when no TV sounds or other background
noises are present. Training the unit in a noisy environment will result
in poor recognition later.
4