Abus RM20 User Manual - page 7
– 18 –
– 19 –
approx.10seconds. Then you can
place the device on the magnet
carryingframe(Fig.1,III.).The
adhesive bond will reach its ultimate
strengthafterapprox.72hours.
DRILLING
Drill a hole into the installation
surface with a 6 mm drill bit and
insert the supplied 6 mm wall plug
intothehole.Guidethesupplied
5 mm countersunk head screw through
the underside of the magnetic mount
(Fig.4)picturedbelowsothatthe
screwwithbeflushwiththe
magnetic mount when it has been
screwedintothewallplug.Pushthe
screwthroughthedrilledhole.
The screw must be fully screwed into
the recess provided on the magnetic
mount to ensure that the unit is held
securely.Takecarenottofastenthe
tones, the unit will continue to
function for a maximum of 60 days
and needs to be replaced before this
60-day period has expired!
INSTALLATIoN
TheRM 20isholdinplacebya
magneticmount.Thismountcan
be fastened to the ceiling in two
differentways,asdescribedbelow.
Please note that only one side of the
magnet can attract the unit
magnetically.
ADHESIVE MoUNTING
To mount the device using adhesion,
only the adhesive included with the
product may be used! The assembly
sitemustbefixed,dryandfreeof
grease, dust and loose paintwork
etc.Asshownin(Fig.3),removethe
information sticker and the protective
filmfromtheappliedadhesiveand
press the magnet carrying frame to
the assembly positionfirmlyfor
Fig.3
390371_MoAnltg RM 20_D_GB_F_NL_I_11.2012.indd 18
14.11.12 13:16