Acer ARMC_3P User Manual - page 92
80
P
RODUCT
U
SER
G
UIDE
Telnet port
Port number at which the ARMC/3P’s Telnet server is listening. If left empty
the default value will be used.
SSH port
Port number at which the ARMC/3P’s Secure Shell (SSH) server is listening.
If left empty the default value will be used.
Bandwidth Limit
The maximum network traffic generated through the ARMC/3P Ethernet
device. Value in Kbit/s.
Enable Telnet access
Set this option to allow accessing the ARMC/3P using the Telnet gateway
(see the Chapter 5: Telnet Console).
Enable SSH access
Set this option to allow accessing the ARMC/3P using the Secure Shell (SSH)
protocol. This SSH console offers the same features as Telnet (see the
Chapter 5: Telnet Console), but uses a secure, encrypted connection
instead.
Disable Setup Protocol
Enable this option to exclude the ARMC/3P from the setup protocol.
LAN Interface Settings
This entry field displays the current settings for the Ethernet/LAN interface of the
ARMC/3P. You may choose between auto negotiation and a fixed setting for the
Ethernet transceiver settings “interface speed” and “duplex mode” in case auto
negotiation does not work correctly.
LAN interface speed
Depending on your network connection you may select an according speed
value for this interface. To adjust the interface automatically choose
“autodetect” (default value). If this selection results in misbehavior of the
interface, choose one of other speed options to work with. The interface will
transmit and receive data with that fixed speed.
LAN interface duplex mode
If necessary you may also select a specific duplex mode. The default value is
set to “autodetect” which leads to an automatic setting of the duplex mode
depend- ing on your network (recommended). As an alternative you may
explicitly set the interface to either “half duplex” or “full duplex” mode.
These settings may also be configured via serial console. See Chapter 3: Initial
Configuration via Serial Console for details.