Baker D30R User Manual

12/3/2009 | 71-022 V6 

D30R 

1 

Users Manual 

Digital Winding Tester 

D30R 

Baker Instrument Company, an SKF Group Company, 

4812 McMurry Ave. Suite 100 

Fort Collins, CO 80525 

(970) 282-1200 

(970) 282-1010 (FAX) 

800-752-8272 (USA Only) 

Note

: This equipment has been tested and found to comply with the limits for a Class A digital 

device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable 

protection against harmful interference with the equipment is operated in its installation. This 

equipment generates uses and can radiate radio frequency energy and, if not installed and used in 

accordance with the product manual, may cause harmful interference to radio communications. If 

this equipment does cause harmful interference, the user will be required to correct the 

interference. 

Due to the phenomena being observed and the material properties being measured, this 

equipment does radiate radio frequency energy while in the active test mode. Care should be taken 

to insure this radio frequency energy causes no harm to individuals or other nearby equipment. 

Information furnished in this manual by Baker Instrument Company, an SKF Group Company,, is 

believed to be accurate and reliable. However, Baker Instrument Company, an SKF Group 

Company, assumes no responsibility for the use of such information or for any infringements of 

patents or other rights of third parties that may result from its use.  No license is granted by 

implication or otherwise under any patent rights of Baker Instrument Company, an SKF Group 

Company. 

Warning:

Baker Instrument Company, an SKF Group Company, assumes no liability for damages consequent 

to the use of this product. No part of this document may be reproduced in part or in full by any 

means such as photocopying, photographs, electronic recording, videotaping, facsimile, etc., 

without written permission from Baker Instrument Company, an SKF Group Company, Fort Collins, 

Colorado.