Baker D30R User Manual - page 9
Safety precautions, CE compliance
12/3/2009 | 71-022 V6
D30R
9
Symbols on equipment
Protective conductor terminal. Located beside black ground test lead
on front panel of instrument.
Earth (ground) terminal
Frame or chassis terminal. Located on rear panel of instrument by
ground terminal.
Warning about hazardous voltage and risk of severe electrical shock or
death. Located beside each red test lead on front panel of instrument.
Other Information
Cleaning & decontamination
The D30R should be kept clean and in a dry environment. To clean the unit, power down and
unplug the instrument. Wipe with a clean water dampened cloth. Do not submerge in water
or other cleaners or solvents. To clean the screen, take a soft water dampened cloth and
gently
wipe the surface.
Technical assistance / Authorized Service Centers
See our website at
www.bakerinst.com
for technical assistance/authorized service center
information. This information will be marked with an asterisk.
Accessory interconnection and use
The D30R are equipped with a footswitch standard. Please see details about these accessories
in later chapters in this manual.
Intermittent operation limits
At this time there are no intermittent operation limits to the use of the AWA unit.
Installation requirements
The unit may be operated
1)
Flat on the bottom of the unit,
2)
Flat on the back of the unit, or
3)
Held at an angle using the rotating handle.
There are no ventilation requirements.
The unit is intended for use in Installation Category II (Portable Equipment) areas and
pollution Degree II Environments where occasional non-conducting condensing pollution can
be encountered.
Unpacking the unit
Carefully remove the following items from the shipping boxes.