Bang & Olufsen BeoSound 5 Encore Installation Manual - page 8
/QDO@QHMFRDSTO
Preparing setup
Perform the next basic settings before continuing to the setup part.
Connect to mains
Connect the power supply to the mains. When the startup procedure is running (takes approximately one minute), the LED lights red and the
screen is black. The product is ready, when the source menu appears on the screen.
Pincode
6GDMSGDLTRHBRXRSDLHRBNMMDBSDCSNSGDL@HMRENQSGDÖQRSSHLDNQG@RADDMCHRBNMMDBSDCEQNLSGDL@HMRENQLNQDSG@M@OOQNWHL@SDKX
LHMTSDRHSB@MNMKXAD@BSHU@SDCAXRVHSBGHMFHSNM@MCDMSDQHMFSGDOHMBNCD(ESGDOHMBNCDHRMNSDMSDQDCSGDLTRHBRXRSDL@TSNL@SHB@KKX
switches to standby after approximately three minutes. The remote control can not be used for entering the pincode.
> Turn the wheel to browse the digits, and press GO to select.
> Turn the wheel to STORE, and press GO.
! If you store a wrong pincode, you get only one more attempt to enter the code, after which the system switches to standby. The system cannot be
switched on again for three hours.
Language
"G@MFDSGDK@MFT@FDSNLDDSSGDBTRSNLDQRODBHÖB@SHNMR
> Use the pointer to highlight MODE, turn the wheel to select SETTINGS, and press GO.
> Use the pointer to highlight SYSTEM SETTINGS, turn the wheel to select LANGUAGE, and press GO.
> Turn the wheel to select the language you want, and press GO.
!MLjPK.-5#014',%QCRRGLEQ
"NMÖQLSGDRDSSHMFRENQONVDQR@UHMF
> Turn the wheel to select SETTINGS and press GO.
> Use the pointer to highlight SYSTEM SETTINGS and turn the wheel to select POWER SAVING and press GO.
> Turn the wheel to select YES or NO and press GO.
YES = power saving (default)
NO = start up faster (increases the standby power consumption).
> Use the pointer to leave the menu.