Banner Q4X Quick start manual
Quick Start Guide
Class 1 laser CMOS sensor with a discrete (PNP or NPN) output. Patent pending.
This guide is designed to help you set up and install the Q4X Sensor. For complete information on programming,
performance, troubleshooting, dimensions, and accessories, please refer to the Instruction Manual at
www.bannerengineering.com
. Search for p/n 181483 to view the Instruction Manual. Use of this document assumes
familiarity with pertinent industry standards and practices.
For illustration purposes, the threaded barrel model Q4X images are used throughout this document.
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to
serious injury or death. This device does not include the self-checking redundant circuitry necessary
to allow its use in personnel safety applications. A sensor failure or malfunction can cause either an
energized or de-energized sensor output condition.
Features
1
2
3
Figure 1. Sensor Features—Threaded Barrel
Models
1. Output Indicator (Amber)
2. Display
3. Buttons
1
2
3
Figure 2. Sensor Features—Flush Mount
Models
Display and Indicators
1
2
Figure 3. Display in Run Mode
The display is a 4-digit, 7-segment LED. The main screen is the Run Mode
screen, which shows the percentage matched to the taught reference
surface. A display value of 999P indicates the sensor has not been taught.
1. Stability Indicator (STB = Green)
2. Active TEACH Indicators
•
COD = Intensity and distance windows for clear object
detection
Output Indicator
•
On—Outputs conducting (closed)
•
Off—Outputs not conducting (open)
Active TEACH Indicators (COD)
•
COD all on = Intensity and distance windows for
clear object detection enabled
Stability Indicator (STB)
•
On—Stable signal within the specified sensing range
•
Flashing—Marginal signal, the target is outside the
limits of the specified sensing range, or a multiple
peak condition exists
•
Off—No target detected within the specified sensing
range
Buttons
Use the sensor buttons (SELECT)(TEACH), (+)(LO/DO), and (-)(MODE) to program the sensor.
Q4X Stainless Steel Laser Sensor for Clear
Object Detection
Original Document
187731 Rev. C
13 September 2016
187731