Banner Q4X Quick start manual - page 2
(SELECT)(TEACH)
•
Press to select menu items in Setup mode
•
Press and hold for longer than 2 seconds to start
the Clear Object Detection TEACH mode
(+)(LO/DO)
•
Press to navigate the sensor menu in Setup mode
•
Press to change setting values; press and hold to
increase numeric values
•
Press and hold for longer than 2 seconds to switch
between light operate (LO) and dark operate (DO)
(-)(MODE)
•
Press to navigate the sensor menu in Setup mode
•
Press to change setting values; press and hold to
decrease numeric values
•
Press and hold for longer than 2 seconds to enter
Setup mode
NOTE: When navigating the menu, the
menu items loop.
Laser Description and Safety Information
CAUTION: Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure. Do not attempt to disassemble this sensor for
repair. A defective unit must be returned to the manufacturer.
Class 1 Lasers
Class 1 lasers are lasers that are safe under reasonably foreseeable conditions of operation, including the use of optical
instruments for intrabeam viewing.
Laser wavelength: 655 nm
Output:
Pulse Duration: 7 µs to 2 ms
Installation
Install the Safety Label
The safety label must be installed on Q4X sensors that are used in the
United States.
NOTE: Position the label on the cable in a location that
has minimal chemical exposure.
1. Remove the protective cover from the adhesive on the label.
2. Wrap the label around the Q4X cable, as shown.
3. Press the two halves of the label together.
COMPLIES WITH IEC 60825-1:2007
CLASS 1
LASER PRODUCT
COMPLIES WITH 21 CFR 1040.10 AND 1040.11
EXCEPT FOR DEVIATIONS PURSUANT TO
LASER NOTICE No. 50, DATED JUNE 24, 2007.
BANNER ENGINEERING CORP.
9714 10TH AVENUE NORTH
MINNEAPOLIS, MN 55441
COMPLIES WITH
IEC 60825-1:2007
CLASS
1
LASER PRODUCT
Figure 4. Safety Label Installation
Q4X Stainless Steel Laser Sensor for Clear Object Detection
2
www.bannerengineering.com - Tel: +1-763-544-3164
P/N 187731 Rev. C