Barco RLS W12 User Manual - page 39

RLS W12  02/12/2014

31

5. Getting Started

5.3  Switching to standby

How to switch to standby

Press power button remain 3 seconds to switch to standby mode 

All custom  settings  are written  to the internal  backup  device.   A message  ’Saving  data ...’ indicates  

this process.  Never switch off the projector while this message is displayed.

When switching to standby, an after cooling process will start to cool down the projector.  The after cool 

time depends on the temperature inside the projector and can vary from 30 second to 5 minutes.

5.4  Power off projector

How to power off

1.  Press first Standby.

2.  Let cool down the projector until the fan speed decreases.  At least 5 minutes.

3.  Switch off the projector with the power switch.  ’0’ must be pressed.

C

AUTION: Never switch off the projector while the message ’Saving data ... ’ is displayed !

5.5  Source selection

Press MENU on the remote control to activate OSD  then select INPUT  for the desired source. Or press 

on the 

keypad to select the input source.

5.6  Changing OSD language

By factory default, the OSD menu of the projector is displayed in English. If you want to change default language. Press the 

MENU on Remote control or keypad, then go to Control -> Languages to select the language that you want.