Barco RLS W12 User Manual - page 45

RLS W12  02/12/2014

37

7.Input

7.5  Auto Power Off

The default value is OFF. If you set it to ON, the projector will automatically shut down after 20 minutes without input signal. 

7.6  Auto Power ON

The default value is Off. If you set it to ON, the projector will automatically start up when it is connected to AC power. If you 

plug the projector’s power cord into an AC socket with a switch, you can use this function to start up the projector using the 

socket’s switch instead of the remote. If you do not need this function, please set it to Off.

7.7  No Signal

When no signal is available at the selected input, the output can be set to blue or black or a logo can be displayed or the 

projector can shutdown after a certain time or auto dimming can be started.

There have 

Logo

, 

Blue

, 

Black

 and 

White

 can choose.

7.8  Auto Image Adjust

You can configure the Auto Image Adjust function to one of the following three modes:

Off =NEVER 

Auto

=When not done before(or when done first time)

Always

=When new source selected or new source connected.