Barco RLS W12 User Manual - page 66
RLS W12 02/12/2014
58
11.Alignment
White level
White level is to set the line from one projector where the other projector last pixel ends. Press to adjust the white
level of the Top, Bottom, Left, Right direction on the projected images.
As shown in the below drawing, the area D is the overlap area of the projected image1 and the projected
image 2. The white level lines that is set where the other projector last pixels ends. Color adjustment for
matching the images is done with projector toolset with customs color space x and y or with input balance
on the OSD.
Black Level
the purpose of black level is in order to compensate the non overlap zones vs the over lap zone. It increase the black level
to the brightness level of the overlap black. It is to adjust the black level of the Top, Bottom, Left, Right direction on the
projected images. It can be set to adjust the primary color of the projector. For instance, select ALL is to adjust the primary
color of Red, Green, and Blue. Or it can be set to adjust the Red, Green and Blue independently.
The function combination of Black Level adjustment and 4 Corners is not available
The function combination of Black Level adjustment and blend along corners is not available.
Image 1
Image 2
A
B
C
D
White Level Lines
Image 1
Image 2
A
B
C
D
White Level Lines
for black level adjustment a black image
needs to be connected on the 2 projectors.
Zone B will have the sum of the blacks
of the 2 projectors. Set the adjustment
line of the black level to the position where
the non active DMD's of the right projector
ends. Set the adjustment line of the black
level to the position where the non active
DMD's of the left projector ends. Adjust
black level of projector A to match the
black level with zone B. Adjust the projector
C to match theblacklevelwithzoneB.
Blend along
corners
Reset
ThefunctioncanresettheScenergiXsettingsontheprojector.Itwillrestoretotheimagestothedefaultthatiswithoutany
ScenergiXfunctionsenabled.
Adjust Lines
WhenthefunctionisON,therewillbeadjustlinesontheimageinordertoeasilyadjustmultipleimages.Press
▲▼◄►on
theremotecontroltoadjustthepositionofthelinesontheimage.
Brilliant Blend
When using the blending with the "bright" or "presentation" mode the blend zone can be improved by selecting the "brilliant
blending" sequence. Note that this can only be done in the native color temp. The other color temperatures will be not
available. Also the brilliant blend function is not applicable when the color mode is in “RGB only”. When select to Brilliant
Blend, a warning message will pop up.