Bauhn AMHST-014 Instruction Manual - Cassette Tape Operation
12
1300 886 649
Model: AMHST-014 Product Code: 48293 01/2015
www.tempo.org
AUS
Instructions (Cont.)
Cassette Tape Operation
• Press the FUNCTION button on the front panel repeatedly, or the TAPE
button on the remote control, to select TAPE mode.
• Adjust the volume and preset equaliser (refer to page 10) to suit your
personal listening preference.
• Use the cassette function buttons for playback control in TAPE mode. For
basic tape playback, proceed as follows:
• Open the cover below the tape decks.
• Depress the button to open the tape compartment.
• Gently tighten the tape, as loose tapes can cause trouble.
• Insert the cassette with the tape facing downwards.
• Shut the tape compartment until it locks audibly.
• Depress the button, until it locks, to play the tape.
• Press the button to interrupt playback.
• Press the button to stop playback.
• Press the key again to open the tape compartment.
Auto-stop function
When the tape has reached the end, the tape deck will switch off automatically.
Extended play
To play two tapes in succession, load a cassette tape in each tape deck.
• Press the button for each tape deck, then press the button for Deck A.
• The tape in Deck B will be played first. At the end, the tape will stop and the
tape in Deck A will start playing automatically.
Recording to tape
When recording observe copyright law. If in doubt consult a lawyer.
Use the following cassette function buttons for recording.
Recording
Play
Rewind
Fast Forward
Stop, Open
NOTE: You cannot record on Chromium (IEC II) or Metal (IEC IV) tapes.
Only use NORMAL Ferro Tapes (IECI) for recording.