Bauhn AMHST-014 Instruction Manual - Repeat Modes
15
1300 886 649
Model: AMHST-014 Product Code: 48293 01/2015
www.tempo.org
AUS
Instructions (Cont.)
•
- Press this button to skip to the start of the track currently played.
Press it again to go to the previous track.
• - Press this button to quickly rewind.
• REPEAT - Press this button to select or cancel repeat play mode.
• PROGRAM - Use this button when storing track numbers to be played into
the memory. Maximum capacity is 20.
Programming tracks for playback
• Select DISC mode (as previously described).
• Place a disc in the CD tray, then close the CD tray.
• Press the STOP button to stop automatic playback.
• Press the PROG button on the remote control to start the program memory.
The "PROG" indicator will illuminate.
• To input the desired track number, use the / or numeric buttons and
then press the PROG button again to save and program the next track.
• Once you have finished programming, press the PLAY/PAUSE button to
start the programmed playback.
• To erase your program, press the STOP button while playing the program.
(The "PROG" indicator should be off when the program is cancelled, if it is
still illuminated, press the PROG button to cancel the program.)
Repeat modes
• Press the REPEAT button on the remote control to select a repeat mode.
The “REP” indicator will start flashing and the current track will be played
over and over until cancelled.
• To repeat all tracks on the disc, press the REPEAT button again; the “REP”
indicator will be steady and all tracks on the disc will be played repeatedly
until cancelled.
• To stop repeat mode, press the REPEAT button again; the “REP” indicator
will go off and the unit will resume normal playback mode.
CD protection
• To keep discs clean, always handle a disc by its edge. Do not touch the
disc surface.
• Do not stick paper or write anything on the surface.
• After playing, store the disc in its case.