BullFrog Spas Owner's Manual - page 13
Page 13
Bullfrog Spas Owner’s Manual
OPERATION
Important: Bullfrog Spas come with either an
Economy, Deluxe or Premium Control System. Please
refer only to the Control System that applies to your
spa.
ECONOMY CONTROL SYSTEM
MASTER CONTROL PAD (Fig. I)
Temperature Adjustment (80°F - 104°F)
Temperature adjustment is controlled by pushing the
“Temp Set” button. The display shows the actual water
temperature unless the button is pressed. When the
button is pressed, the display will show the set
temperature. Pressing the button a second time will
cause the set temperature to increase or decrease
depending on what direction was last chosen. Each
successive press will change the set temperature in
the same direction.
If the opposite direction is desired, release the button
and let the display revert to the actual water
temperature again. Press the button to display the set
temperature, and again to make the temperature
change in the desired direction.
Jets
Press the "Jets" button to operate the pump. Press the
button once to turn on the low-speed pump. Press the
button again to turn on the high-speed pump, and
again to turn off the pump. The low-speed pump will
automatically turn off after 2 hours and the high-
speed pump after 30 minutes. Due to Automatic Spa
Control, the low-speed pump will start automatically
when the heater is turned on, when a filter cycle is
activated, or when a freeze condition is detected. If
the low-speed pump is on under the Automatic Spa
Control, it can only be deactivated by entering the
Standby Mode.
Light
Press the "Light" button to turn the spa light on and
off. The spa light will turn itself off after 4 hours of
operation.
Standard and Economy Mode
The Standard Mode is the default operation mode for
the spa. When in Standard mode, the spa maintains
the desired temperature at all times. In Economy
mode, the spa only heats water during filter cycles
and has a fixed temperature setting of 100°F. To
activate the Economy Mode, change the temperature
setting on the Master Control Pad down to 80°F by
pressing the “Temp Set” button. Press the button
again and your spa will enter into the Economy Mode.
(Figure I) Economy Control Pad