BullFrog Spas Owner's Manual - page 20
Page 20
Bullfrog Spas Owner’s Manual
Locking the Temperature Only
To lock the temperature, press either the “Warmer” or
“Cooler” button to initiate the “set heat” mode. Next,
and within a 3 second time span, press the “*” button
then the “#” button then the “”Warmer” button. When
locked, the display will show the spa temperature, the
“set heat” statement, and the lock symbol. All buttons
will be frozen except the “*” button which is used to
initiate the unlock sequence.
Unlocking the Control Pad
By pressing the “*” button then the “#” button then the
“Cooler” button within 2 seconds, the lock symbol will
disppear and the control pad buttons will work again.
Auxiliary Control Pads - Optional (See Fig. M)
Pump 1: Press the "Jets 1" button to operate pump 1.
Press the button once to turn on the low-speed pump.
Press the button again to turn on the high-speed
pump, and again to turn off the pump. The low-speed
pump will automatically turn off after 2 hours and the
high-speed pump after 30 minutes.
Pump 2: Press the "Jets 2" button to operate pump 2
(if installed). Press the button once to turn on the low-
speed pump. Press the button again to turn on the
high-speed pump, and again to turn off the pump.
The low-speed pump and the high-speed pump will
automatically turn off after 30 minutes.
FILTER CYCLES:
Preset Filter Cycles: Your spa will automatically filter
itself for a 2-hour period every 12 hours. The first
filter cycle will begin at 2:00 AM and will continue
until 4:00 AM. The second filter cycle will begin at
2:00 PM and will continue until 4:00 PM. When a filter
cycle is active, it will be indicated on the display with a
message stating “Filter 1” for the first (AM) cycle or
“Filter 2” for the second (PM) cycle. During filtration,
the low-speed pump and ozone sterilizer (if installed)
will run. The low speed of pump 2 purges for 5
minutes at the beginning of each filter cycle.
Custom Filter Cycles: While you are not required to
set filter cycles, if you want to change them, press the
“Time” button and the time of day will be shown.
Then press the “*” button and “set time” will appear
on the display. Then press the “*” button within 3
seconds and “SET START FILTER 1” (AM cycle) will
appear on the display.
Press the “Warmer” or “Cooler” button to reset the
filter start time.
Next, press the “*” button and when “SET HEAT” is on
the display, press the “Warmer” (on) button to heat the
water during filtering, or press the “Cooler” (off)
button to disable the heater during filtering.
(Figure M) Auxiliary Control Pad