BullFrog Spas Owner's Manual - page 19
Page 19
Bullfrog Spas Owner’s Manual
ac
words “set heat”. Each time either of these buttons is
pressed again, the set temperature will increase or
decrease depending upon which button is pressed.
After three seconds, the LCD will automatically display
the current spa temperature.
Jets 1
Press the "Jets 1" button to operate pump 1. Press the
button once to turn on the low-speed pump. Press the
button again to turn on the high-speed pump, and
again to turn off the pump. The low-speed pump will
automatically turn off after 2 hours and the high-
speed pump after 30 minutes. Due to Automatic Spa
Control, the low-speed pump will start automatically
when the heater is turned on, when a filter cycle is
activated, or when a freeze condition is detected. If
the low-speed pump is on under the Automatic Spa
Control, , it can only be deactivated by entering the
Standby Mode.
Jets 2
Press the "Jets 2" button to operate pump 2 (if
installed). Press the button once to turn on the low-
speed pump. Press the button again to turn on the
high-speed pump, and again to turn off the pump.
The low-speed pump & the high-speed pump will
automatically turn off in 30 minutes.
Light
The spa light has 3 settings. Pressing the "Light"
button changes the intensity from the brightest
setting to the dimmest setting, then turns it off. The
spa light will turn itself off after 4 hours of operation.
Standard and Economy Mode
Press the "#" button to switch between Economy and
Standard modes. When in Economy mode, the spa
only heats water during filter cycles. In Standard
mode, the spa maintains the desired temperature at
all times.
Standby Mode
(Use when removing JetPaks or cleaning the filter)
Press either the "Warmer" or "Cooler" button and then
the "Light" button. The display will show "Stby" and all
functions will be disabled except for freeze control.
Press any button to reset the system.
Locking the Control Pad
To lock the entire control pad, press the “*” button
then the “#” button then the “Warmer” button all
within 3 seconds. When locked, the display will show
the spa temperature along with the lock symbol. All
buttons will be frozen except the “*” button which is
used to initiate the unlock sequence.