BullFrog Spas Owner's Manual - page 6
Page 6
Bullfrog Spas Owner’s Manual
UPGRADING YOUR BULLFROG
SPA
The following are possible upgrades for your Bullfrog
Spa:
New JetPak™ designs: As new jet types and styles
become available so will new innovative JetPak
modules (Fig. B). Check will your authorized Bullfrog
Spa Dealer on a yearly basis to see what's available.
PowerPlus™: When you're ready for more horsepower
and more jets, just call your authorized Bullfrog Spa
Dealer and ask for PowerPlus.
WellSpring™ Ozone Sterilizer: For cleaner spa water,
we use the most simple, reliable, user-friendly,
affordable ozone system on the market. If your spa
did not come with one, its well worth the investment
IMPORTANT: Your spa was designed, tested, and UL
Listed with a Bullfrog ZO-310 Ozone Sterilizer. No
other Ozone Sterilizer is recommended for your
Bullfrog Portable Spa.
Tablet Feeder - Chlorine/Bromine: This Tablet
Feeder allows you to sanitize your spa water each time
your filter pump turns on, saving you from having to
do so. Also, your Tablet Feeder is out of sight and yet
easy to get to.
Miscellaneous Upgrades: For upgrades as they
become available, keep in touch with your authorized
Bullfrog Spa Dealer.
INSTALLATION & SET-UP
Before attempting to install or use your spa, please
read the U.L. Safety Instructions, the Additional Safety
Instructions, as well as all of the Installation
Instructions that follow:
SELECTING A SITE FOR YOUR SPA:
Your Bullfrog Spa was designed for either indoor or
outdoor use. Whether indoors or outdoors, please
adhere to the following guidelines:
1. Select a site that is stable and capable of
supporting the weight of your spa, its water, and the
people using it (refer to the “Technical Specification
Sheet” in this manualfor the Filled Weight of your
spa). If installed on a suspended floor/deck, the floor/
deck should be capable of supporting your spa. If you
have concerns on this matter, please contact a
qualified Licensed Contractor.
2. Select a surface that is flat and reasonably level.
This surface must provide continuous support for the
entire bottom of the spa. Do not shim or block up the
spa creating voids below the spa.
3. Avoid installing the spa in a pit or low area where
water may accumulate and damage the spa or its
equipment. Choose a site where water will drain away
(Figure B) Several JetPak™ Variations