C. Crane CCWiFi Instruction Manual - Menu Time-Out
CC WIFI
13
CC WiFi
Page 15
Menu Time-Out
When a radio station is playing — if BACK or SELECT is pressed, the
radio will go into menu selection mode. If no radio controls are used
within ten seconds, the radio will “time-out” and go back to the cur-
rently playing radio station.
Setting the Time and Date
Note:
At any point, you can use the BACK button to start over at the
previous screen.
1. If you are currently listening to a radio station, briefly press the dial
once to access the Primary Menu. You can also access the
Primary Menu by pressing and holding the BACK button.
The Primary Menu contains six options: STATIONS, PERSONAL
RADIO, MY STUFF, MEDIA PLAYER, CONFIGURE and ALARM
CLOCK.
2. Turn the main dial until “Configure” shows in brackets — press the
dial to select.
Media Player
<
Configure
>
3. Turn the dial clockwise to “Clock Setup” — press the dial to select.
Register
<
Clock Setup
>
<
Set Time/Date
>
Clock Format
4. Turn the dial to “Set Time/Date” — press the dial to select..
5. Turn the dial until the hour setting is correct — press the dial to
select.
6. Turn the dial until the minute setting is correct — press the dial to
select.
CC WiFi
Page 15
Menu Time-Out
When a radio station is playing — if BACK or SELECT is pressed, the
radio will go into menu selection mode. If no radio controls are used
within ten seconds, the radio will “time-out” and go back to the cur-
rently playing radio station.
Setting the Time and Date
Note:
At any point, you can use the BACK button to start over at the
previous screen.
1. If you are currently listening to a radio station, briefly press the dial
once to access the Primary Menu. You can also access the
Primary Menu by pressing and holding the BACK button.
The Primary Menu contains six options: STATIONS, PERSONAL
RADIO, MY STUFF, MEDIA PLAYER, CONFIGURE and ALARM
CLOCK.
2. Turn the main dial until “Configure” shows in brackets — press the
dial to select.
Media Player
<
Configure
>
3. Turn the dial clockwise to “Clock Setup” — press the dial to select.
Register
<
Clock Setup
>
<
Set Time/Date
>
Clock Format
4. Turn the dial to “Set Time/Date” — press the dial to select..
5. Turn the dial until the hour setting is correct — press the dial to
select.
6. Turn the dial until the minute setting is correct — press the dial to
select.