Cabletron Systems MRXI-22 User Manual - Chapter 3

3-1

CHAPTER 3

INSTALLATION

This chapter outlines the procedure for installing your MRXI and 

connecting it to a network. Ensure that your network meets the

guidelines and requirements outlined in Chapter 2, Installation 

Requirements/Specifications, before installing the MRXI.

3.1

UNPACKING THE  MRXI

Unpack the MRXI as follows:

•

Remove the two plastic bags containing the accessories.

•

Remove the MRXI from the shipping box.

•

Slide the two foam end caps off the MRXI.

•

Remove the MRXI from the protective plastic bag and set it aside to 

prevent damage.

Before you install the MRXI visually inspect the unit and check the 

contents of the accessory package. Contact Cabletron Systems Technical 

Support immediately if you find any discrepancies.

3.2

ATTACHING THE STRAIN RELIEF BRACKET

Attach the strain relief bracket to the front of the MRXI as follows:

1. Locate the strain relief bracket and four 8-32 x 3/8” screws from the 

MRXI installation kit.

Warning: Use of longer screws may cause damage to the unit or 

electrical shock.

2. Attach the strain relief bracket to the bottom of the MRXI as shown in 

Figure 3-1.