Cal Amp VIPER SC+ 100 series User Manual - page 100
Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C
| Page 90
4.6. SERIAL
The Serial page contains four tabs: Com Port, Serial Port, VLAN, and Advanced.
4.6.1. COM PORT AND SETUP PORT
COM Port is the first (left-most) tab and the Setup Port tab is next to it to the right. To navigate to the COM Port tab,
select Serial from the main menu; to navigate to the Setup Port tab, select Serial from the main menu and then select
Setup Port. The two tabs are nearly identical and provide access to all of the same settings—the only difference is the
port that the configuration settings are for. In each of the two tabs, you can enable or disable the applicable port and
set serial communication parameters for it.
Figure 53 – Serial – COM Port